Configuring Advanced Settings; Configuring Hik-Connect - HIKVISION EKI-K82T46 User Manual

3. In the General Settings interface, you can configure Working Mode, NIC Type, IPv4 Address, IPv4
Gateway, MTU, DNS, DHCP, and DNS Server.
The valid value range of MTU is 500−9676.
NOTE:
If the DHCP server is available, you can click the DHCP checkbox to automatically obtain
an IP address and other network settings from that server.
NOTE: For DS-7600NI-Q1/P and DS-7600NI-Q2/P Series NVRs, you need to configure the internal
NIC address, so that IP addresses are assigned to the cameras connected to the PoE
interfaces.
4. After having configured the general settings, click the Apply button to save the settings.
Working Mode
Two 10M/100M/1000M NIC cards are provided, and they allow the device to work in multi-address and net-
fault tolerance modes.
Multi-Address Mode: The parameters of the two NIC cards can be configured independently. You can
•
select LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route, and for the system connecting with the extranet the data
will be forwarded through the default route.
Net-Fault Tolerance Mode: The two NIC cards use the same IP address, and you can set the Main NIC to
•
LAN1 or LAN2. In this way, in case of one NIC card failure, the device will automatically enable the other
standby NIC card so as to ensure normal running of the system.
11.2

Configuring Advanced Settings

11.2.1

Configuring Hik-Connect

NVR User Manual 061220NA
Figure 166, Network Settings Interface
118