HIKVISION EKI-K82T46 User Manual page 104

4. Click the OK button to finish settings.
Full Screen Monitoring
When an alarm is triggered, the local monitor (VGA, HDMI, or BNC monitor) displays in full screen the video
image from the alarming channel configured for full screen monitoring.
If alarms are triggered simultaneously in several channels, their full-screen images will be switched at an
interval of 10 seconds (default dwell time). A different dwell time can be set by going to Menu >
Configuration > Live View > Full Screen Monitoring Dwell Time.
Auto-switch will terminate once the alarm stops and you will be taken back to the Live View interface.
NOTE: You must select during "Trigger Channel" settings the channel(s) you want to make full
screen monitoring.
Audible Warning
beep
Trigger an audible
Notify Surveillance Center
Sends an exception or alarm signal to remote alarm host when an event occurs. The alarm host refers to
the PC installed with the Remote Client.
The alarm signal will be transmitted automatically at detection mode when a remote
NOTE:
alarm host is configured. Refer to
configuration.
E-Mail Linkage
Send an e-mail with alarm information to a user or users when an alarm is detected. Refer to
Email
for details of e-mail configuration.
Trigger Alarm Output
Trigger an alarm output when an alarm is triggered.
1. Enter Alarm Output interface, Menu > Configuration > Alarm > Alarm Output.
2. Select an alarm output, and set alarm name and dwell time.
3. Click Schedule button to set the arming schedule of alarm output.
NOTE: If "Manually Clear" is selected in the Dwell Time drop-down list, you can clear it only by
going to Menu > Manual > Alarm.
4. Set up arming schedule of the alarm output. Choose one day of the week. Up to eight time periods can
be set within each day.
NVR User Manual 061220NA
when an alarm is detected.
Figure 149, Alarm Output Setup Interface
Configuring More Settings for details of alarm host
Configuring
104