Configuring Disk Clone - HIKVISION EKI-K82T46 User Manual

NOTE: If the quota capacity is set to
for record and picture capture.
12.5

Configuring Disk Clone

Purpose
If the S.M.A.R.T. detection result declares the HDD is abnormal, you can choose to clone all the data on the
HDD to an inserted eSATA disk manually. Refer to
Before You Start
An eSATA disk should be connected to the device.
1. Enter the HDD Advanced Setting interface, Menu > HDD > Advanced.
2. Click the Disk Clone tab to enter the disk clone configuring interface.
3. Make sure the usage of the eSATA disk is set to Export. If not, click the Set button to set it. Choose
Export and click the OK button.
NOTE: The capacity of destination disk must be the same as that of the clone source disk.
4. Check the HDD checkbox to be cloned in the Clone Source list.
NVR User Manual 061220NA
0
, then all cameras will use the total capacity of the HDD
HDD Detection
Figure 219, Disk Clone Configuration Interface
Figure 220, Setting eSATA Usage
for details of S.M.A.R.T. detection.
142