Table of Contents
Advertisement
2. To use a third party ceiling mount kit, ensure the screws used to attach a mount to the
projector meet the following specifications:
•
Screw type: 35 mm for Christie One Mount (P/N: 108-506102-XX)
M4(4X)
Adjusting the projected image
Adjust the projected image's height and horizontal tilt for better viewing.
Adjusting the height of the projector
The projector is equipped with elevator feet for adjusting the image height.
1. Locate the adjustable foot you want to modify on the bottom of the projector.
2. Rotate the adjustable ring clockwise to raise the projector or counter clockwise to lower it.
For stacking application, the elevator feet of the upper projector must be adjusted to increase the
height of this projector to avoid the interference between two projectors. For more information on
stacking projectors, refer to Stacking application on page 21.
Inspire Series Installation and Setup Guide
020-002097-01 Rev. 1 (11-2023)
Copyright ©2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Lens
480.00
486.00(WITH ID RIB)
240.00
85.00
170.00
Installation and setup
Unit: mm
20
Advertisement
Table of Contents
