Adjusting The Rod Assembly - Christie HS 2K Series Service Manual

2. Enter Service mode.
See Entering Service mode
3. Select ADC Calibration.
4. Press Enter.
After a few seconds, the ADC calibration status changes from Doing to Done.

Adjusting the ROD assembly

Avoid over-adjusting the ROD to prevent damage.
Warning! If not avoided, the following could result in death or serious injury.
• Do not look into the projector lens when the laser is on. The bright light may result in permanent
eye damage.
• This projector has a built-in Class 4 laser module. Never attempt to operate the projector without
all covers properly installed, unless instructed to do so in this manual for service.
1. Update the special firmware for rod adjusit, in case DMD burned.
2. Remove the top cover.
See Removing the top cover
3. To power on with the top cover removed, firmly hold the interlock switch on the left-side cover.
4. Project an image of 100 inch in a dark environment (< 2 Lux).
5. Enter Service mode.
See Entering Service mode
6. Click Test Pattern, select the White Screen test pattern.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 19.
on page 59.
on page 19.
Service setups
25