Replacing A Cartridge Bay With A Drive Bay - Qualstar XLS Series Technical & Service Manual

9.4 Replacing a Cartridge Bay with a Drive Bay

9.4 Replacing a Cartridge Bay with a Drive Bay
This section provides instructions for replacing a cartridge bay with a drive bay. Shown in
Figure 9-9, a drive bay can accommodate up to four tape drive assemblies.
Figure 9-9 Two drive bays (viewed from the front with the front panel removed)
Important:
Procedure overview:
with a drive bay.
Step
1 Shut down the library and power it off
2 Remove the cartridge bay
3 Install the drive bay
4 Install the tape drives
Power on the library, update the
5 hardware configuration, and scan the
fiducials and inventory
Table 9-4 Overview of replacing a cartridge bay with a drive bay
9-10
If you simply need to replace one cartridge bay with
another, refer to Section 9.4.1 on page 9-11
the cartridge bay and Section 9.5.2 on page 9-20
install the replacement.
Table 9-4 provides an overview of replacing a cartridge bay
Task
to remove
Refer to...
Section 6.2 on page 6-1
Section 9.4.1 on page 9-11
Section 9.4.2 on page 9-13
Section 8.5 on page 8-8
Section 17.5 on page 17-12
to
501610 Rev. 07-01-19