Qualstar XLS Series Technical & Service Manual page 267

6. Turn all four jam nuts on the MEM clockwise until they push up against the
frame. See
Figure 15-16 Tightening a leveling foot
15.1.7 Lowering the Carousel Supports
The two carousel supports prevent the carousel from sagging when it is loaded with
cartridges. These supports must be tight against the floor before you install the
cartridges.
To avoid damaging the base of the carousel, do not install cartridges in
the carousel slots unless the carousel supports are fully extended and
snug against the floor.
To lower the carousel supports, follow these steps:
1. Locate the front carousel support for the MEM. See
Figure 15-17 Location of the front carousel support
2. Using a 3/4-inch open-end wrench, turn the jam nut to loosen the support. See
Figure 15-14 on page
3. Using the same wrench, extend the support until it touches the floor. See
Figure 15-15 on page
XLS Library Technical Service Manual
Figure 15-16.
Turn jam nut until
it pushes against
the frame
CAUTION
15-12.
15-12.
15
Replacing MEM Components
Figure 15-17.
15-
253