Qualstar XLS Series Technical & Service Manual page 308

17.3 Restarting the XLS if a Door was Opened
4. After the power-on processes are complete, check the status of the LEDs, as
follows:
– From the back of the library, look at each tape drive assembly and confirm
– From the back of the library, look at each power supply and confirm that the
– From the back of the library, look at the battery module. If the Charge LED is
– From the front of the library, look at the Attention LED, which should be off.
5. As required, log into X-Link and put the XLS in logical mode. See
on page
17.3 Restarting the XLS if a Door was Opened
This section includes instructions for applying power to the XLS and scanning the
cartridge inventory. Use the instructions in this section if you opened a door while the
library was shut down, but did not change the fiducial positions or the hardware
configuration. For example, you would use these instructions after replacing any of the
following components:
• A door interlock sensor
• A door-lock solenoid
• An I/O port open sensor
• A light curtain sensor
• X-motor assembly
• Y-motor assembly
Important:
17-4
that the Drive Status LED is green, indicating that the tape drive is installed
and powered on.
PWR Good LED is green and the Fault LED is off.
illuminated, the battery module may not be fully charged. It can take up to 10
minutes for the battery to fully charge.
5-11.
Do not use the instructions in this section if you:
• Removed the front panel
• Installed or removed a cartridge magazine
• Installed or removed a cartridge bay
• Installed or removed a drive bay
• Installed or removed an I/O port
• Installed or removed a MEM or expansion pod
Instead, refer to
Section 17.5 on page
Section 17.4 on page 17-8
17-12.
Section 5.4.4
or
501610 Rev. 07-01-19