Qualstar XLS Series Technical & Service Manual page 297

16.5 Reinstalling the Rear Side Panel
To reinstall the rear side panel on the XLS-812300, follow these steps:
1. Holding the side panel with both hands, place the panel next to the XLS-812300
and secure it with the five Torx screws you removed in
page
Figure 16-16 Installing the side panel on the expansion pod
2. Insert one screw in the hole at the bottom of the panel. Using a #2 Phillips
screwdriver, tighten the screw.
3. After installing the expansion pod, power on the XLS as described in
Section
16.6 Applying Power
To apply power after installing an expansion pod, follow these steps:
1. Open the door on the XLS-812300 (the I/O port(s) can be open or closed).
XLS Library Technical Service Manual
16-2. See Figure 16-16
16.6.
16
for the location of the three top screws.
Installing an Expansion Pod
Section 16.1 on
16-
283