Removing A Tape Drive - Qualstar XLS Series Technical & Service Manual

8.4 Removing a Tape Drive

5. Confirm that Off is now reported in the Status–Power column of the tape drives
table.
Important:
6. Check the Drive Status LED on the back of the tape drive assembly. If the LED is
amber or off, it is safe to remove the tape drive. See
Figure 8-5 Status LEDs on Fibre Channel drive carrier
8.4 Removing a Tape Drive
To remove a tape drive, follow these steps:
1. Check to ensure that the Drive Status LED is amber or off.
2. Disconnect any cables and terminators from the tape drives.
8-6
You may need to press Refresh to update the contents
of the table.
Figure 8-5.
501610 Rev. 07-01-19