Qualstar XLS Series Technical & Service Manual page 291

7. Hold the bottom hinge mount against the XLS-812300 and route the
expansion-pod controller cable through the channel on the bottom hinge mount.
See
Figure 16-7 Routing the expansion-pod controller cable through the bottom hinge mount
8. Attach the bottom hinge mount to the XLS-812300 using one alignment pin and
three flat-head screws.
9. Install a plastic shim on the four hinge pins. See
Plastic shim
Figure 16-8 Installing a plastic shim on a hinge pin
XLS Library Technical Service Manual
Figure 16-7.
16
Installing an Expansion Pod
Figure 16-8.
16-
277