10.3.2 Installing A Side Panel - Qualstar XLS Series Technical & Service Manual

10.3 Replacing a Side Panel
3. Using a #2 Phillips screwdriver, remove the two screws. See
Figure 10-16 Removing the screws from the side panel
4. Carefully slide the panel up until you can lift the hooks out of the corresponding
slots on the frame. See
Figure 10-17 Removing a side panel

10.3.2 Installing a Side Panel

To install a side panel, follow these steps:
1. Holding the side panel with both hands, carefully lower it into place. Make sure
that the hooks on the panel engage with the corresponding slots on the frame.
10-12
Figure 10-17.
Figure 10-16.
501610 Rev. 07-01-19