Qualstar XLS Series Technical & Service Manual page 208

12.4 Replacing the X-Motor Assembly
12.3.2 Installing the X-Axis Cable and Cat Track
To install the X-axis cable and cat track, follow these steps:
1. Put the cat track and cable into position.
2. If you are replacing the cat track, attach it to the X-beam using two Phillips
screws.
3. Carefully slide the cable through the cat track.
4. Lift up on the X-beam cover and slide the cable under the cover.
5. Attach one end of the flex cable to the X-motor adapter. See
6. Replace the screws that hold the X-beam cover in place.
Note:
7. Replace the two screws attaching the cat track flex cable to the mounting bracket
for the flex cable adapter.
8. Reattach the flex cable to the adapter card. See
9. Replace the gripper assembly. See
10. Reapply power to the library. See
11. Align the gripper with the left back wall (see
right back wall (see
(see
12.4 Replacing the X-Motor Assembly
This section provides instructions for replacing the X-motor assembly. The X-motor
assembly controls the movement of the handler along the X-axis.
Important:
12-22
The X-beam cover for the XLS-832700 has 12 screws (6 large and 6
small); the X-beam covers for the XLS-820500 and XLS-812300 have 10
screws.
Section 12.1.5 on page
Section 12.1.6 on page
For clarity, this procedure has been photographed with
the front panel removed. However, you can replace the
X-motor while the front panel remains in place.
Figure 12-18 on page
Section 12.1.3 on page
Section 17.4.1 on page
Section 12.1.4 on page
12-10), and any installed MEMs
12-11).
Figure 12-19.
12-20.
12-7.
17-8.
12-9), the
501610 Rev. 07-01-19