Qualstar XLS Series Technical & Service Manual page 142

9.3 Installing and Removing Door Slots
Installing the Cartridge Magazines
To install the cartridge magazines on the door, follow these steps:
1. Locate the four threaded mounting holes on the uppermost magazine faceplate.
The faceplate can hold two magazines, so it includes two upper and two lower
mounting holes. See
Magazine mounting
holes (use top
threaded hole)
Figure 9-5 Location of mounting holes for cartridge magazines on magazine faceplate
2. Use two 6-32 x 3/8 pan-head screws to attach a cartridge magazine to one side of
the magazine faceplate. Be sure to use the holes shown in
3. Attach the remaining 21 cartridge magazines.
Important:
4. As required, insert cartridges into each slot.
5. Refer to
hardware configuration, and scan the fiducials and inventory.
9-6
Figure 9-5.
Be sure to install all 22 cartridge magazines. The XLS
will not operate correctly if any of the door slots are
missing.
Section 17.5 on page 17-12
Figure
to power on the library, update the
9-5.
501610 Rev. 07-01-19