Removing The Battery Module - Qualstar XLS Series Technical & Service Manual

7.2 Replacing the Battery Module
7.2.1

Removing the Battery Module

To remove the battery module, follow these steps:
1. Locate the two screws that attach the battery module to the power/PC bay. See
Figure
Figure 7-9 Location of the battery module screws
2. Using a Phillips screwdriver, remove the two screws and set them aside. You will
reuse these screws to install the replacement module.
3. Using one hand to grasp the handle and the other to support the battery module's
weight, carefully slide the module out of the power/PC bay. See
page
Important:
7-8
7-9.
7-9.
The battery module should slide out easily. If there is
any resistance, adjust the position of the battery module
and try again.
Figure 7-10 on
501610 Rev. 07-01-19