Qualstar XLS Series Technical & Service Manual page 286

16.1 Removing the Side Panels from the XLS-812300
Items shipped with the expansion pods:
• Top hinge mount
• Bottom hinge mount
• Front L brace
• Alignment pins (2)
• Plastic shims (4)
• 6-32 x 5/16 Torx screws (5)
• 6-32 x 3/4 flat-head screws (6)
• 10-32 x 1-1/4 socket-head screws (3)
• Right expansion pod:
– 5/16-18 x 1/2 socket-head screws (3)
– 5/16 flat washers (3)
• Left expansion pod:
– 3/8-16 x 1/2 socket-head screws (3)
– 3/8 flat washers (3)
16.1 Removing the Side Panels from the XLS-812300
To remove the side panels from the XLS-812300, follow these steps:
1. On the side of the XLS-812300 where you will install the expansion pod, locate
the front and back side panels.
2. Using a #2 Phillips screwdriver, remove the single screw at the bottom that
secures the front side panel to the frame. See
Figure 16-1 Location of screw for the front side panel
16-2
Figure 16-1.
501610 Rev. 07-01-19