Qualstar XLS Series Technical & Service Manual page 240

14.3 Replacing an I/O Port Open Sensor
Procedure overview:
sensor.
Step
1 Shut down the library and power it off
2 Remove the I/O port open sensor
3 Install the I/O port open sensor
4 Power on the library
Table 14-3 Overview of replacing an I/O port open sensor
Precautions:
Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD). If possible, use a grounded static
protection wristband. If a wristband is not available, touch a known
grounded surface.
Required tools and equipment:
• 1/4-inch nut driver
14.3.1 Removing an I/O Port Open Sensor
To remove an I/O port open sensor, follow these steps:
1. Shut down the library and power it off. See
2. Open the door closest to the I/O port.
14-6
Table 14-3 provides an overview of replacing an I/O port open
Task
CAUTION
Make sure you have the following:
Refer to...
Section 6.2 on page 6-1
Section 14.3.1
Section 14.3.2 on page 14-7
Section 17.3 on page 17-4
Section 6.2 on page 6-1.
501610 Rev. 07-01-19