Powering Off The Gripper - Qualstar XLS Series Technical & Service Manual

4.5 Inspecting and Cleaning the Gripper and Barcode Reader
Required tools and equipment:
• Cotton swabs
• Isopropyl alcohol
• Kimwipes® or lint-free cloth for cleaning lenses
Procedure overview:
gripper pads and sensors and the mirror on the barcode reader.
Step
1 Power off the gripper
2 Inspect and clean the parts if necessary
Power on the gripper and resume
3
operation
Table 4-1 Overview of inspecting and cleaning gripper components
4.5.1

Powering Off the Gripper

Before inspecting or cleaning gripper components, you must power off the gripper. Follow
these steps:
1. If necessary, press the Home button in the upper right corner of any page to
return to the Home page.
2. Select Service View or Show All to display the Service portlet, shown in
Figure
Figure 4-9 Service portlet
3. From the Change Mode section, select Physical Mode to put the XLS in physical
mode. See
4-8
Make sure you have the following:
Table 4-1 provides an overview of inspecting and cleaning the
Task
4-9.
Section 5.4 on page
Refer to...
Section 4.5.1
Section 4.5.2 on page 4-9
Section 4.5.3 on page 4-11
5-8.
501610 Rev. 07-01-19