Qualstar XLS Series Technical & Service Manual page 118

7.6 Replacing the Power/PC Bay Assembly
2. Unplug the power cord. Use your thumb to release the latch. See
Push on latch
to remove
connector
Figure 7-21 Attaching the power cord
3. Remove the power supplies (see
(see
power/PC bay.
4. Follow the instructions in
out of the library's frame.
5. Using a Phillips screwdriver, loosen the three capture screws that attach the
EMI shield and remove the shield. See
Figure 7-22 Location of the screws for the EMI shield
6. Remove the strain relief plate, and disconnect any cables to the HBAs.
7-22
Section 7.2.1 on page
Section 7.3.1 on page 7-11
Section 7.1.1 on page
7-8); you will install them in the replacement
Figure 7-22.
Figure 7-21.
7-3) and battery module
to slide the power/PC bay
501610 Rev. 07-01-19