Installing And Removing Door Slots; Installing Door Slots - Qualstar XLS Series Technical & Service Manual

9.3 Installing and Removing Door Slots

6. Refer to
fiducials and inventory.
9.3 Installing and Removing Door Slots
This section provides instructions for installing and removing the door pack 110-tape kit.
With the kit installed, a door can hold an additional 110 cartridge slots.
9.3.1

Installing Door Slots

Important:
Procedure overview:
Step
1 Shut down the library and power it off
2 Install the magazine faceplates
3 Install the cartridge magazines
Power on the library, update the
4 hardware configuration, and scan the
fiducials and inventory
Table 9-2 Overview of installing door slots
Required tools and equipment:
• Door pack 110-tape kit, including:
– 11 magazine faceplates
– 22 cartridge magazines
– 6-32 x 5/16 flat-head screws (33)
– 6-32 x 3/8 pan-head screws (44)
• #2 Phillips screwdriver
Installing the Magazine Faceplates
To install the magazine faceplates, follow these steps:
1. Shut down the library and power it off. See
9-4
Section 17.4 on page 17-8
If you decide to install the door pack 110-tape kit, be
sure to install all 22 cartridge magazines. Otherwise,
the library will not operate correctly.
Table 9-2 provides an overview of installing door slots.
Task
Make sure you have the following:
to power on the library and scan the
Refer to...
Section 6.2 on page 6-1
"Installing the Magazine
Faceplates" on page 9-4
"Installing the Cartridge
Magazines" on page 9-6
Section 17.5 on page 17-12
Section 6.2 on page 6-1.
501610 Rev. 07-01-19