Qualstar XLS Series Technical & Service Manual page 279

6. Power off the left or right carousel, as follows:
– If you want to power off the carousel attached to the left side of the LRM,
– If you want to power off the carousel attached to the right side of the LRM,
When the carousel controller is powered off, you will hear a click as the door-lock
solenoids are disengaged.
15.3.2 Removing the Carousel Motor
To remove the carousel motor, follow these steps:
1. Access the carousel motor bracket and alignment pin, as follows:
– If the MEM is to the right of the LRM, remove the right side panel from the
– If the MEM is to the left of the LRM, use a 1/4-inch Allen wrench to remove
Important:
XLS Library Technical Service Manual
select Power Off Carousel Left from the Carousels section of the page.
select Power Off Carousel Right from the Carousels section of the page.
MEM, as described in Section 10.3.1 on page
or
the six 5/16 x 1/2-inch socket-head screws securing the LRM to the MEM.
Refer to the instructions in
You can leave the XLS powered on when you remove the
side panel or the MEM. However, if you remove the
MEM from the LRM, be aware that you will need to
rescan all fiducials and cartridges after reattaching the
MEM.
15
10-11.
Section 15.1.5 on page
Replacing MEM Components
15-10.
15-
265