Qualstar XLS Series Technical & Service Manual page 292

16.2 Installing the Expansion Pod Mounting Hardware
10. Attach the front L brace to the XLS-812300 as shown in
– If the expansion pod to the right of the XLS-812300:
– If the expansion pod is to the left of the XLS-812300:
Important:
Figure 16-9 Front L brace on the left side of the XLS-812300
16-8
Use three 5/16 x 1/2 socket-head screws and three 5/16-inch flat
•
washers.
Install the screws from the outside of the XLS. That it, insert them into
•
the brace, then into the pem nuts on the XLS frame.
Use three 3/8 x 1/2 socket-head screws and three 3/8-inch flat washers
•
Install the screws from the inside of the XLS. That is, insert them into
•
the XLS frame, then into the pem nuts on the brace.
• If a fixed port assembly is installed on the upper left
position, you need to remove the fixed port to install the
middle screw. Refer to
• If an I/O port is installed in the upper left position, press
the I/O port solenoid to open the port. See
on page
Section 11.2.1 on page
11-2.
Figure 16-9. Note that:
11-7.
Figure 11-2
501610 Rev. 07-01-19