Qualstar XLS Series Technical & Service Manual page 261

2. Locate the two socket-head cap screws on each bracket. See
1
3
Left side of MEM
Figure 15-8 Location of screws on the carousel shipping locks
– The screws on the left side of the brackets (screws 1 and 2 in
– The screws on the right side of the bracket (screws 3 and 4 in
3. Use a 5/16-inch Allen wrench (right-angled, if possible) to remove the two
shipping locks (screws 3 and 4 in
4. Using the same wrench, gradually lower the carousel as follows:
a.
b.
c.
Important:
XLS Library Technical Service Manual
have a stationary PEM nut and function to raise and lower the carousel.
are shipping locks and function to keep the carousel from rotating.
Loosen screw 1 a few turns.
Loosen screw 2 a few turns.
Repeat steps a and b until screws 1 and 2 can be removed from the brackets.
To ensure that the carousel is lowered evenly and to
avoid equipment damage, be sure to loosen screws 1 and
2 in tandem as described.
15
Replacing MEM Components
Right side of MEM
Figure 15-8).
Figure 15-8.
4
2
Figure 15-8)
Figure 15-8)
15-
247