Qualstar XLS Series Technical & Service Manual page 173

11 Replacing I/O Ports and Fixed
This chapter provides instructions for the following tasks:
• Replacing an I/O port (see
• Replacing a fixed port assembly (see
• Upgrading a fixed port assembly to an I/O port (see
11.1 Replacing an I/O Port
This section describes how to remove an I/O port and replace it with another I/O port.
Procedure overview:
Step
1
2
3
4
5
6
Table 11-1 Overview of replacing an I/O port
Required tools and equipment:
• #2 Phillips screwdriver with a 5-inch or longer blade, magnetized if possible
• Needle-nosed pliers or spring attachment tool
11.1.1 Removing an I/O Port
To remove an I/O port, follow these steps:
1. Shut down the library and power it off. See
XLS Library Technical Service Manual
Table 11-1
Task
Shut down the library and power it off
Remove the front panel
Remove the I/O port
Install the I/O port
Replace the front panel
Power on the library and scan the
fiducials and inventory
Port Assemblies
Section 11.1)
Section 11.2 on page
provides an overview of replacing an I/O port.
Refer to...
Section 6.2 on page 6-1
Section 10.1 on page 10-1
Section 11.1.1
Section 11.1.2 on page 11-5
Section 10.2 on page 10-7
Section 17.4 on page 17-8
Make sure you have the following:
Section 6.2 on page
11-7)
Section 11.3 on page
6-1.
11-9)
11-1