Installing A Fan; Replacing System Controller Components - Qualstar XLS Series Technical & Service Manual

7.5 Replacing System Controller Components

7.4.2

Installing a Fan

To install a fan, follow these steps:
1. Holding the fan by the thumb screw, lower the fan into the power/PC bay. See
Figure
Figure 7-15 Replacing a fan
2. Turn the thumb screw clockwise until hand tight.
3. Follow the instructions in
back into the library's frame.
7.5 Replacing System Controller Components
This section provides instructions for accessing and replacing the following components in
the system controller:
• Any of the PCI cards, including the Fibre Channel and SCSI host bus adapter
(HBA) cards and the CAN bus controller card.
• Hard drive
7-14
7-15.
Thumb screw
Section 7.3.2 on page 7-12 to slide the power/PC bay
501610 Rev. 07-01-19