Sliding The Power/Pc Bay In; Replacing A Fan - Qualstar XLS Series Technical & Service Manual

7.4 Replacing a Fan

3. Refer to the following sections as required:
– To replace a fan, see
– To replace a PCI card or hard drive, see
– To replace the entire power/PC bay assembly, see
7.3.2

Sliding the Power/PC Bay In

To slide the power/PC bay back into place, follow these steps:
1. Holding the power/PC bay by a power supply handle or by the flanges on either
side, slide the bay into the library's frame.
2. Replace the four screws (two on either side). See
Insert screws
Figure 7-13 Replacing the screws on the left side of power/PC bay
7.4 Replacing a Fan
This section provides instructions for replacing either of the two cooling fans in the
power/PC bay.
Important:
7-12
Section 7.4
The fans are hot swappable. You can replace a fan while
the library is powered on.
Section 7.5 on page 7-14
Section 7.6 on page 7-21
Figure 7-13.
501610 Rev. 07-01-19