Qualstar XLS Series Technical & Service Manual page 325

Appendix A
This appendix lists physical addresses for every possible cartridge slot or tape drive
location in the XLS-832700, XLS-820500, or XLS-812300.
You may need to know the library's physical addresses when you install the tape drives
and cartridges and when you perform various operations on the physical library. These
physical addresses are fixed and cannot be changed. In this way, they differ from the SCSI
element addresses for a logical library, which are assigned when the logical libraries are
created.
To determine the physical address for a particular cartridge slot or tape drive within the
physical library, refer to the figures listed in
Model For physical addresses of...
All cartridge slots on the rear wall and the
optional door slots
XLS-832700 The rear wall assuming that drive bays are
installed instead of cartridge bays
The tape drives as viewed from the back
All cartridge slots on the rear wall and the
optional door slots
XLS-820500 The rear wall assuming that drive bays are
installed instead of cartridge bays
The tape drives as viewed from the back
All cartridge slots on the rear wall and the
optional door slots
The rear wall assuming that drive bays are
XLS-812300
installed instead of cartridge bays
The tape drives as viewed from the back
The slots in the expansion pods
Left and right door slots, assuming that all
possible cartridge slots are installed.
All Models
The I/O port slots
The fixed port slots
The cartridge slots on the carousel
MEM
(XLS-832700 and XLS-820500)
Table A-1 Physical addresses for the XLS
XLS Library Technical Service Manual
Library Addresses
Table A-1:
Refer to...
Figure A-1 on page A-2
Figure A-2 on page A-3
Figure A-3 on page A-4
Figure A-4 on page A-5
Figure A-5 on page A-6
Figure A-6 on page A-7
Figure A-7 on page A-8
Figure A-8 on page A-9
Figure A-9 on page A-10
Figure A-10 on page A-11
Figure A-11 on page A-12
Figure A-12 on page A-13
Figure A-13 on page A-13
Figure A-14 on page A-14
A-
311