Qualstar XLS Series Technical & Service Manual page 106

7.2 Replacing the Battery Module
3. Push on the battery module to ensure that the connectors are fully seated against
the power/PC bay.
Important:
4. Using a Phillips screwdriver, replace the two screws and turn them clockwise
until hand tight. See
Figure 7-11 Location of screws for the battery module
Do not tighten the screws unless the battery module is fully seated. Do
not overtighten the screws.
7-10
If the Charge LED on the battery module illuminates,
the battery module may not be charged. It can take up
to 10 minutes for the battery in the replacement module
to fully charge.
Figure 7-11.
CAUTION
501610 Rev. 07-01-19