Qualstar XLS Series Technical & Service Manual page 145

2. Using a Phillips screwdriver, remove the three screws that attach a faceplate to
the door. See
Figure 9-7 Removing the magazine faceplate from the door
3. Remove the remaining magazine faceplates.
4. On the back of the door, locate the two holes for the DOR barcode label bracket.
5. Using a Phillips screwdriver, insert two screws through the bracket and into the
door. See
Figure 9-8 DOR barcode label bracket (back of door shown)
Important:
6. Refer to
hardware configuration, and scan the fiducials and inventory.
XLS Library Technical Service Manual
9
Figure 9-7.
Figure 9-8.
To ensure correct library operation, you must install a
DOR barcode label bracket after removing door slots.
Section 17.5 on page 17-12
Installing or Replacing Cartridge Slots and Drive Bays
to power on the library, update the
9-
131