Qualstar XLS Series Technical & Service Manual page 256

15.1 Installing a MEM
Required tools:
• 3/4-inch open-end wrench
• #2 Phillips screwdriver
• 3/8-inch Allen wrench
• 5/16-inch Allen wrench
• 5/32-inch Allen wrench
• 1/4-inch Allen wrench
• Precision level
Equipment shipped with the MEM:
• Two bullet-nose alignment pins
• Six 5/16-18 x 1/2-inch socket-head screws
• Gripper alignment cartridge (Qualstar part number: 620059). See
Figure 15-1 Gripper alignment cartridge
15-2
Make sure you have the following:
Figure 15-1.
501610 Rev. 07-01-19