Qiagen QIAcuity 911000 User Manual page 163

bars of individual replicates disappear and only one bar is shown at the sample label that represents
the mean edited fraction value of the replicates. When there are no replicates within selected wells
for edited target the bars don't change. The corresponding well IDs of the replicates are shown on
the x axis. This is also applied in same way by default to the view where targets are in different
reaction mixes. In this case individual replicate results are not available. Mean values are calculated
and shown over all replicates that are included in the well selection only. If there are further
replicates of the same sample that are not included in the well selection, they are not considered in
the calculated mean value and show their individual results values.
To add the Concentration diagram to the report, click Add to report. For more information on
reports, see section Reports.
Copy number variation
The Copy number variation tab contains diagrams that visualize the data related to copied genes
in targets of interest and reference targets. The analysis results are put into list views, heatmaps,
point diagrams, and concentration diagrams.
Note: Saving copy number variation tests is not yet provided
Setting up a copy number variation analysis
1. Click the applicable wells in the plate layout. For more information, see section Selecting
wells for analysis.
QIAcuity User Manual 07/2020 163