4.8
Removing O-rings and seals
When performing certain maintenance procedures, you must remove O-rings or seals from
instrument components. An O-ring removal kit can be purchased separately.
Figure 4–1:
Tool 1
Notice:
To avoid scratching the O-ring or seal, take care while using the removal tools to
remove it from components.
To remove an O-ring:
1.
Use the forked end of tool 1 to impale the O-ring or seal.
2.
Pull the O-ring or seal from its groove; if necessary, use tool 2 as an aid.
3.
Dispose of the O-ring or seal in accordance with local environmental regulations.
4.9
Cleaning the instrument case
Notice:
To avoid damaging the instrument, do not use abrasives or solvents to clean the
instrument's case.
Use a soft cloth, dampened with water, to clean the outside surfaces of the instrument.
O-ring removal kit
Tool 2
Warning:
To avoid spreading contamination, dispose of the O-ring or seal in
accordance with local environmental regulations.
September 7, 2016, 715003560IVD Rev. C
Page 49