Danfoss VLT AQUA Drive FC 200 Programming Manual page 112

Parameter Description
3.13.8 14-9* Fault Settings
14-90 Fault Level
Option: Function:
[0] Off Use this parameter to customize Fault levels. Use
*
[0] Off with caution as it will ignore all Warnings
& Alarms for the chosen source.
Failure Parameter
10 V low 1490.0
24 V low 1490.1
1.8 V supply low 1490.2
Voltage limit 1490.3
Earth Fault
1490.4
Earth Fault 2
1490.5
Derag Limit Fault
1490.16
Table 3.18 Table for Selection of Choice of Action when Selected Alarm Appears
D = Default setting. x = possible selection.
1) Only these faults are configurable on the FC 202. Due to a software limitation with array parameters, all of the other will show in the MCT 10
Set-up Software. For the other parameter indices, writing any other value than its current value (i.e. the default value) will return a "value out of
range" error. Thus, you are not allowed to change the fault level for the non-configurable ones.
2) This parameter has been 1490.6 in all firmware versions up to 1.86.
®
VLT AQUA Drive Programming Guide
Alarm
1)
1)
1, 2)
®
MG20O602 - VLT is a registered Danfoss trademark
14-90 Fault Level
Option: Function:
[1] Warning
[2] Trip
[3] Trip Lock
Off
1 X
47 X
48 X
64 X
14
45
100
Warning Trip Trip Lock
D
D
D
D
D X
D X
D X
111
3 3