Danfoss VLT AQUA Drive FC 200 Programming Manual page 36

Parameter Description
0-76 DST/Summertime Start
Range: Function:
Size related [ 0 - 0 ] Sets the date and time when
*
summertime/DST starts. The date is
programmed in the format selected in
0-71 Date Format.
0-77 DST/Summertime End
Range: Function:
Size related [ 0 - 0 ] Sets the date and time when
*
summertime/DST ends. The date is
programmed in the format selected in
0-71 Date Format.
0-79 Clock Fault
Option: Function:
Enables or disables the clock warning, when the
clock has not been set or has been reset due to a
power-down and no backup is installed. If MCB
109 is installed "enabled" is default
[0] Disabled
*
[1] Enabled
0-81 Working Days
Array with 7 elements [0] - [6] displayed below parameter
number in display. Press [OK] and step between elements with
▲ ▼
[ ] and [ ].
Option: Function:
Set for each weekday if it is a working day or a non-
working day. First element of the array is Monday. The
working days are used for Timed Actions.
[0] No
*
[1] Yes
0-82 Additional Working Days
Array with 5 elements [0] - [4] displayed below parameter
number in display. Press [OK] and step between elements with
▲ ▼
[ ] and [ ].
Range: Function:
Size related [ 0 - 0 ] Defines dates for additional working days
*
that normally would be non-working
days according to 0-81 Working Days.
0-83 Additional Non-Working Days
Array with 15 elements [0] - [14] displayed below parameter
number in display. Press [OK] and step between elements with
▲ ▼
[ ] and [ ].
Range: Function:
Size related [ 0 - 0 ] Defines dates for additional working days
*
that normally would be non-working
days according to 0-81 Working Days.
®
VLT AQUA Drive Programming Guide
0-89 Date and Time Readout
Range:
0
*
®
MG20O602 - VLT is a registered Danfoss trademark
Function:
[0 - 0 ] Displays the current date and time. The date and
time is updated continuously.
The clock will not begin counting until a setting
different from default has been made in 0-70 Date
and Time.
3 3
35