Error Requiring Restart - MUTOH ValueJet VJ-1204 Operation Manual

VJ-1204 OPERATION MANUAL
7.2.5

Error requiring restart

This section describes errors requiring restart and remedies.
An error requiring restart is displayed if a fatal operational failure such as the following occurs.
• When an obstacle that prevents printing occurs
• When a problem occurs with the electrical circuit, such as the PCB, motor and sensor of the printer
• When a failure in the printer control program occurs
If an error requiring restart occurs, the printer stops operating after performing the following operations.
1. The drive power automatically shuts down.
2. All lamps on the operation panel blink, and the buzzer rings continuously.
3. The error message is displayed on the operation panel.
Pressing any key on the operation panel stops the beeping.
For an error requiring restart, operation will return to normal after removing the cause of the error and
restarting the printer.
If the same error continues to be displayed, contact the your local MUTOH dealer. Be sure to tell us the
code no. of the error message when you contact us.
No. Display
1 E** Error [ ]
NOTE
• "***" in the error message is the code no. that indicates what type of error occurred.
• The command code representing the error occurred may be indicated in [ ].
• For the settings on your PC side, refer to the Operating Manual attached with your PC.
Description
A problem that does not
have a remedy has
occurred.
7-13
Remedy
1. Remove obstacles such
as paper scraps in the drive
system.
2. Confirm that the replaced
items are correctly
attached.
3. Turn OFF the printer
power, and turn it ON again
after 10 seconds or longer.
7 Troubleshooting
Reference
7.3 The media
is jammed
6.1 Replacing
consumable
components