Error Requiring A Restart - MUTOH ValueJet VJ-1204 User Manual

6.2.5 Error requiring a restart

This section describes the details of the display when an error requiring a restart occurs and its remedy.
An error requiring a restart is displayed if a fatal operational failure such as the following occurs.
•
When an obstacle which prevents printing occurs.
•
When a problem occurs with the electrical circuit (PCB, motor, sensor, etc.) of the printer.
•
When a failure on the printer control program occurs.
If an error requiring a restart occurs, the printer stops operating after performing the following operations.
1. The power automatically shuts down.
2. All lights on the operation panel blink, and the buzzer rings continuously.
3. The error message is displayed on the operation panel.
Pressing any key on the operation panel stops the beeping.
For an error requiring a restart, operation will return to normal after removing the cause of the error and
restarting the printer.
If the same error continues to be displayed, contact your local MUTOH dealer. Be sure to tell us the code no.
of the error message when you contact us.
Message Cause
E** Error [ ] A problem that does not have a remedy.
Notes
•
"***" in the error message is the code no. that indicates what type of error occurred.
•
The command code representing the error occurred is indicated in [ ].
•
For the settings on your PC side, refer to the Operating Guide of your PC.
Remedy
1. Remove obstacles such as paper scraps in the
drive system.
2. Check that the replaced items are correctly
attached.
3. Switch off the printer power, and turn it on again
after more than 10 seconds.
118 AP-75740 – Rev 1.1 – 23/01/2007
User's Guide ValueJet 1204
Chapter 6: Troubleshooting