Table of Contents
Advertisement
7.3.5 Error requiring a restart
Following are descriptions and their solutions of error requiring a restart.
Error requiring a restart are displayed when the following fatal error has occurred during printer operation.
Foreign material disturbing the printer operation is involved in the printer.
An electrical circuit (such as board, motor, or sensor) failure has occurred.
An error on control program of the printer has occurred.
If error requiring a restart has occurred, the printer works as shown below then stops.
(1) Power relating to the driving system is shut off automatically.
(2) All indicator lights on the operation panel are turned on and beeps sound continuously.
(3) An error message is displayed on the operation panel.
Press any key on the operation panel to stop the beep sounds.
If error requiring a restart has occurred, solve the problems to restart the printer and delete the error.
If the same error message is displayed again, contact MUTOH local dealer. Be sure to inquire by the code
numbers of the error messages.
Display
N°
1
System Err I****Err[]
Notes :
*** in error messages are code numbers indicating what kind of error occurred.
[ ] may indicate the command code of the error.
For the settings on a computer, refer to the computer's operation manual.
System Err
E***
OOOOOOOOOOOOO
Descriptions
An error which cannot
be solved promptly has
occurred.
242
[
]
Solutions
1. If foreign material such
as a piece of media or
media dust is involved in
the driving system,
remove them.
2. Make sure that the
replaced parts are
installed correctly.
3. Turn OFF the printer.
After 10 seconds or more
have passed, turn it back
ON.
User's Guide – Toucan Hybrid
References
When media jams
occur
Replacing
consumables
AP-750, Rev. 1.1 –- 23/04/04
Advertisement
Table of Contents
