Setting Feeding Method - GRAPHTEC FC9000 Series User Manual

2.8

Setting Feeding Method

Feeding method for the loaded media is set.
Operation
1
If you have already loaded the media, the MEDIA TYPE
menu appears. Select the media type to suit the loaded
media.
For the roll media, check that the media stopper is unlocked
and then select a media type on the MEDIA SELECT screen.
When selecting [ROLL-1 FRONT EDGE] pressing the [1] key
Select this when you have loaded a roll media and you wish
to start cutting or plotting from the leading edge.
The width and leading edge of the roll media are detected.
When selecting [ROLL-2 CURRENT POSITION] pressing the [2] key
Select this when you have loaded a roll media and you wish
to start cutting or plotting from a point beyond the leading
edge.
Only the width of the roll media is detected.
When pressing the [3] key to select [SHEET]
Select this when a cut sheet has been loaded. The width,
leading edge, and trailing edge of the sheet are detected.
Media stopper
Release the
media stopper
Pull the media stopper
forward and lower it.
Before doing the media set selection, make sure
to release the media lock.
Supplement
The CONTINUE menu parameter appears
when the media set lever is raised and then
lowered again after media was previously
loaded, making it possible to select the
previous settings.
When pressing the [4] key to select
"CONTINUE".
When using the same media without changing
the position of the media, the CONTINUE
function enables the continued use of the
plotting area, pen position and origin position
was lowered. If the current media is the same
plotter does not detect the media's edges.
2-27
CAUTION