GRAPHTEC FC9000 Series User Manual page 107

4
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE screen is displayed.
5
Press the [1] key (OFF).
Confirm the settings and it will return to the COPY MODE screen.
6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES screen is displayed.
7
Press the POSITION (
setting value.
8
Number of copies will be selected, and it will return to COPY MODE
screen.
9
Press the [3] key (COPY MODE SETTINGS).
COPY MODE SETTINGS screen is displayed.
10
Press the POSITION (
current setting for [1] key (COPY SPACE X), [2] key (COPY
SPACE Y) and [4] key (CROSS CUT SPACING).
[3] key (CROSS CUT) can be set by pressing the [1] key (OFF)
or the [2] key (ON).
) keys and increase or decrease the
) keys to increase or decrease the
4-17
Supplement
Number of copies can be set as much as it
The initial value for the number of copies is
always 1.
Supplement
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
Supplement
COPY MODE SETTINGS can be set when
MEDIA CHANGE MODE is turned OFF.
COPY SPACE can be set from 1.0 mm to
50.0 mm.
CROSS CUT SPACING can be set when
CROSS CUT is turned ON.
To use the CROSS CUT function, set the
copy interval in the feed direction to 20 mm or
more.
This setting is maintained even if the power is
turned off.