Table of Contents
Advertisement
Error
LCD Display
Displayed
E01019
E01021
E01022
E05001
E05002
E05003
E05004
E05006
E05007
E05008
E05009
E05010
Cause
The plotter is defective.
Load on the motor was too large.
The plotter is defective.
Load on the motor was too large.
The plotter is defective.
There was a heavy load on the up and
down function of the tool carriage.
copied.
There is no data to copy.
Media valid area to copy is too small.
The push roller is not on the grit roller.
Distance between the bottom left and top
right of the AREA setting is less than 10
mm.
Test pattern for the TOOL OFFSET ADJ.
cannot start plotting because the start
position is at the edge of the media.
External memory (USB memory) cannot be
Barcode cannot be scanned.
Barcode cutting is not available when
Rotation is set to ON.
16-13
Solution
and turn on the plotter after turning it off
once.
Do not use heavy media.
and turn on the plotter after turning it off
once.
Do not use heavy media.
Please clear any obstruction in the up and
down function of the tool carriage and turn
the power back on.
If the error display continues to show,
please contact the store where you bought
the product or our Customer Center.
Perform normal cutting not using the copy
mode.
Perform normal cutting by sending the data,
then use the copy mode.
Use larger media.
Set the push roller on the grit roller.
Perform the AREA setting again.
Set the start position inside the media.
Insert external memory (USB memory).
Check the print result of Barcode.
Set Rotation is set to OFF to use Bacode
cutting.
Advertisement
Table of Contents
Troubleshooting
