Take-up operation is performed arbitrarily
Possible Cause
Sensor response does not stop.
Roll media is loosely taken up
Possible Cause
Media is strong resilient.
The paper core for take-up runs idle.
Solution
Make sure that the sensor unit is not
blocked by media or a basket.
Solution
Put tension on the roll media by inserting
a paper core with the same width into the
slack part that can be done at the time of
take-up. The swell may stop.
Make sure that the stopper of the media
18-20
Reference
Preparing to Cut (Take-up)
Reference
Preparing to Cut (Take-up)
Preparing to Cut (Take-up)