GRAPHTEC FC9000 Series User Manual page 129

6
Press the [4] key (TEST ARMS SENSOR).
TEST ARMS SENSOR screen is displayed.
7
Press either the [1] key (TYPE 1) or the [2] key (TYPE 2)
depending on the type of the registration mark to be used.
Following message is displayed.
8
Move the tool to the position to start scanning of the
registration mark by pressing the POSITION (
MARK TYPE 1
Move the tool inside this
area
9
The plotter will automatically detect the registration mark and cut the
peak of each registration mark.
10
cutting position is shifted.
Registration mark scan area
) key.
MARK TYPE 2
Move the tool inside this
area
5-15
Supplement
It will return to ARMS SETTING screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
Supplement
It will return to TEST ARMS SENSOR screen
without changing the settings when you press
the [ESC] key (CANCEL).
Supplement
Following error is displayed when the
registration mark was not scanned properly.
Press the [1] key (RETRY) to scan again, or the
[ESC] key (CANCEL) to exit.