GRAPHTEC FC9000 Series User Manual page 344

16.5
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the transmission
of cutting data is performed correctly.
CAUTION
to move immediately after selecting to print the dump list.
Supplement
There may be a difference in the RS-232C transmission condition or the command setting when the printed output and the display of
transmission data does not match. Check the transmission condition and the command.
If the command setting is "Auto", the dump list of the cutting data is not output. Please set the command to "GP-GL" or "HP-GL".
Operation
1
2
Set the pen tool to the tool holder (Backward) and select the
condition where the pen tool is set.
3
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4
Press the POSITION ( ) key (TEST).
TEST screen (1/2) is displayed.
Supplement
See "Loading Media (Paper or Marking Film)"
for loading the media.
Supplement
See "Attaching a Tool" for setting the pen tool.
For changing the tool conditions please refer
to "Selecting Tool Condition", and for tool
settings please refer to "Setting the Tool".
16-22