GRAPHTEC FC9000 Series User Manual page 370

4
Cut the loaded roll media (or media of the same width) to
about 1.2 m and prepare the support media. Make the cutting
end face as straight as possible.
5
Paste a support media straight and evenly to the paper core
for take-up.
Pass the pasted support media between the take-up roller
(drive) and the center bar.
* If the support media is not pasted straight, it may cause
take-up problems.
* Please change the pasting place according to the length of
the media.
Same width as loaded roll media
90° 90°
90° 90°
Tape
Support media
18-12
Center bar