GRAPHTEC FC9000 Series User Manual page 366

3
Load the roll media on the stock shaft so that the tip of roll
media is facing upward.
Determine the position of the roll media and hold the roll
media with the supplied stopper. Once the position is
determined, tighten the stopper screw to secure it.
Stopper
4
Push the tip of the roll media forward from the back of the
FC9000. Make sure to pull it so that there is no slackening
across the roll media's route.
If the screw of the stopper is loose, media skew
may occur. Please tighten the stopper screw
Stopper
18-8
CAUTION
www.delinit.by