Starting Point Setting - GRAPHTEC FC9000 Series User Manual

4
Press the [1] key (AXIS MODE).
AXIS MODE screen is displayed.
5
Press the [2] key (AXIS ALIGNMENT).
6
7
Press the [PAUSE/MENU] key.
It will return to default screen.

Starting point setting

Misalignment of the origin position and angle of X-Y axis is corrected.
By using this function, you can set again the paper plotted already.
Before aligning the coordinate axes, axis alignment can be performed easily by plotting the X axis line and origin
position so that the origin position and coordinate axis can be known in advance.
Plot the X axis line and the origin position inside the cutting area so that it can be set even in a tilted state.
If the origin position and the X axis are plotted in the immediate vicinity of the cutting area, the set position
becomes outside the cutting area and it will not be able to perform the alignment.
Operation
1
Set the media with the plotted alignment mark.
2
Attach the cutter plunger or pen to the tool holder.
Supplement
It will return to AXIS SETTING screen (1/1)
without changing the settings when you press
the [ESC] key (CANCEL).
Supplement
Make sure that the push rollers are on the
media in the area where the media moves.
This alignment is a correction assuming that
the media is set slightly diagonally. If the media
misalignment is too large, the media may come
off.
Supplement
When attaching the cutter plunger to the tool
holder, pay attention to the attaching position.
Attach the tool to Tool Holder 1 (forward).
See "Attaching a Tool".
13-6