Graphtec Studio - GRAPHTEC FC9000 Series User Manual

Graphtec Studio

Step 1: Create registration mark (alignment mark) data.
When printing and cutting, it is necessary to attach registration marks (alignment marks) in order to know exactly
the printing position.
Margin is necessary around the registration marks.
When printing on sheet media, the following margins are required.
Leading edge
MARK TYPE 1 15mm or more
MARK TYPE 2 17mm or more
When printing on roll media, it is necessary to provide a margin of 6
registration mark of the second sheet. In addition, margins of 15 mm
or more must be provided at the left and right edges.
* The printing position may be different depending on the printer you
want to use, therefor It's recommended to take a margin as long as
several mm.
Operation
1-
1 Open the "Registration Marks" tab.
Specify the pattern, length, thickness, reference position of
registration mark.
Registration marks are created on the design screen.
MARK TYPE 1
Right and left
Trailing edge
edges
35mm or more 15mm or more
37mm or more 15mm or more
MARK TYPE 2
14-11
Margin