GRAPHTEC FC9000 Series User Manual page 367

5
Lock the media stopper (Raise while pulling forward) and pull
it out evenly so that the roll media is straight. Please load so
that the roll media always rests on the media sensor.
Media sensor
6
Position the media and the push rollers to correspond with
the width of the media.
See "Loading Media (Paper or Marking Film)" and "Aligning
the Push Rollers" in Chapter 2.
7
Pull the media taut to make sure that there is no slack in the
conveyance path, and then raise the media set lever to lower
the push rollers.
Release the lock from the media stopper (Pull the media
stopper forward and lower it.)
Media sensor
Media set lever
18-9
Supplement
When cutting, slide to unlock the media stopper
(Pull down the media stopper.).
Lock
Media stopper
CAUTION
During a cutting operation, be sure to keep
your hands, hair, and so forth away from the
media stocker and stock shaft.
stock shafts etc. when loading the media.
Deviations and errors may result if the stock
shaft is misaligned when plotting begins.
Slide the
media stopper
Media stopper