Setting Axis Alignment - GRAPHTEC FC9000 Series User Manual

13.3
Adjusting Coordinate Axes
Supplement
After aligning, the alignment will be canceled when the following occurs.
· A new origin point is set.
· The media again is set.
· The Rotation is set. (Please set the Rotation before axis alignment.)
The axis alignment point at this time moves according to the Rotation setting.
displayed.
If you set the 1st and 2nd points to the same point, the axis alignment will be cleared.

Setting axis alignment

Set to axis alignment mode.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [2] key (AXIS).
AXIS SETTING screen (1/1) is displayed.
3
Press the [2] key (AXIS MODE).
AXIS MODE screen is displayed.
13-5