GRAPHTEC FC9000 Series User Manual page 71

9
Press the [ESC] key (CANCEL).
It will return to CONDITION setting screen.
10
Press the [COND/TEST] key.
It will return to default screen.
is achieved.
Adjustment of Offset
Check the corners of the triangles and rectangles. See "Setting the
if it is cut too much.
Adjustment for Half Cutting
backing sheet.
If the backing sheet has been cut through, either the FORCE setting
is too high or the cutter-blade tip is extended too far. If the backing
sheet shows only a few traces of the cutter blade, either the FORCE
Adjustment for cutting out
extended.
Adjustment when using plotting pen
without any faint lines. See"Setting the Force" or setting the FORCE.
Supplement
How to check offset
Check if the offset value is set correctly by
following.
Supplement
2-45
Increase the offset value.
Optimal offset value.
Decrease the offset value.